Ergodox keyboard is finally here!

By | February 10, 2014

After a long wait, I finally got my <a href=”http://ergodox.org”>Ergodox</a> delivered. It took a couple of month, but the guys at <a href=”http://massdrop.com”>Massdrop</a> did a great job procuring and shipping the kit.

The build itself wasn’t too difficult. By far the most painful part was the soldering of the surface mounted diodes. The diodes are quite tiny, must be aligned properly (they are diodes after all), and there are a bunch of them to solder. This was the first time soldering for me, and it took me a good 3 hours or so to finish this part. I highly recommend checking each diode connection with a multimeter to make sure that each one is connected correctly… it’ll likely save a lot of time later.

The rest of the build went pretty smoothly, except for this one time when I had to go back and re-solder the Teensy board because a bad soldering job resulted in one column of keys not working. After a few more hours of work, here’s what I had:

A working Ergodox!

Now, I’m in the process of learning to type on this keyboard… and it’s taking some time. More on that later.

Leave a Reply

Your email address will not be published. Required fields are marked *